Test Description
The number below refers to the step number on the diagnostic table.
- 3: This step tests for the proper operation of the circuit in the high voltage range.
DTC P0462 (3.6L LY7)
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Instrument Cluster Schematics Connector End View Reference: Engine Control Module (ECM) Connector End Views in Engine Controls - 3.6L (LY7) or Inline Harness Connector End Views in Wiring Systems |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 |
|
0.5 V | Go to Step 3 | Go to Diagnostic Aids |
| 3 |
|
4 V | Go to Step 5 | Go to Step 4 |
| 4 | Test the signal circuit of the fuel level sensor for a short to ground. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 9 | Go to Step 6 |
| 5 | Inspect for poor connections at the harness connector of the fuel level sensor. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 9 | Go to Step 7 |
| 6 | Inspect for poor connections at the harness connector of the ECM. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 9 | Go to Step 8 |
| 7 | Replace the fuel level sensor. Refer to Fuel Level Sensor Replacement
in Engine Controls - 3.6L (LY7). Did you complete the replacement? |
- | Go to Step 9 | - |
| 8 | Replace the ECM. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 9 | - |
| 9 |
|
- | Go to Step 2 | System OK |