Low Engine Oil Level Indicator Inoperative

Step	Action	Yes	No
Schematic Reference: Instrument Cluster Schematics Connector End View Reference: Engine Control Module (ECM) Connector End Views for the 3.6L engine or Powertrain Control Module (PCM) Connector End Views for the 3.8L engine
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Turn ON the ignition. With the scan tool, observe the Engine Oil Level Switch parameter in the ECM/PCM Data List or the IPC ECM/PCM Data Lists. Does the Engine Oil Level Switch parameter display OK?	Go to Testing for Intermittent Conditions and Poor Connections	Go to Step 3
3	Replace the instrument panel cluster (IPC). Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 4	-
4	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2