LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Allure (CANADA) V6-3.6L >> Repair and Diagnosis >> Transmission and Drivetrain >> Transmission Control Systems >> Sensors and Switches - Transmission and Drivetrain >> Sensors and Switches - A/T >> Transmission Temperature Sensor/Switch >> Service and Repair >> Thermo Element Replacement

Thermo Element Replacement


Thermo Element Replacement

Tools Required
^ J34094-A Thermo Element Height Gage

Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the oil pan.





3. Remove the thermo element pins (120, 123) and the washers.
4. Remove the thermo element (121) and the thermo element plate (122).

Installation Procedure





1. Use the J34094-A to set the middle thermo pin (123).
2. Install the new thermo element plate (122).
3. Install the pin (120) and the washer.
4. Use the J34094-A to set the height of the pin and the washer furthest from the accumulator.
5. Use the J34094-A to set the height of the second pin (120) and the washer.





6. Install the thermo element (121) between the two pins (120). The V in the thermo element (121) must contact the thermo element plate (122).
7. Install the oil pan.
8. Lower the vehicle.
scientia non olet · About LEMON Manuals