Rear

SEAT BELT RETRACTOR REPLACEMENT - REAR

REMOVAL PROCEDURE




1. Remove the rear window trim panel, as required.
2. Remove the rear sound barrier, as required.
3. If removing the center retractor, remove the belt bezel from the rear window shelf. Pass the bezel and seat belt through the rear shelf bezel opening.




4. Remove the rear seat belt retractor bolt.
5. Remove the rear seat belt retractor from the vehicle.

INSTALLATION PROCEDURE
1. Position the rear seat belt retractor in the vehicle.




2. Install the rear seat belt retractor bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

IMPORTANT: Be sure to seat the alignment tabs.

Tighten the rear seat belt retractor bolt to 68 N.m (50 lb ft).

3. If installing the center retractor, pass the seat belt through the bezel opening and install the belt bezel.
4. Return the rear sound barrier to its installed position. Refer to Sound Barrier Replacement - Rear Seat Back in Interior Trim.




5. Install the rear seat belt retractor anchor bolt to the floorpan.

Tighten the rear seat belt retractor bolt to 42 N.m (31 lb ft).

6. Install the rear window trim panel to its installed position.