Antenna Cable Replacement

ANTENNA CABLE REPLACEMENT

REMOVAL PROCEDURE




1. Remove the rear seat cushion.
2. Remove the rear seat back.
3. Remove the left rear quarter lower panel.
4. Remove the left rear upper quarter trim panel.
5. Lower the rear of the headliner. Refer to Headliner Replacement in Interior Trim.
6. Disconnect the antenna cable (2) from the radio antenna module.




7. Remove the lower center pillar trim panel.
8. Remove the left lower pillar garnish molding.
9. Adjust the carpet for access to the antenna cable (1) and body harness as required. Refer to Carpet Replacement - Front in Interior Trim.




10. Disconnect the antenna cable from the antenna extension cable (1).
11. Cut off the visible ends of the antenna cable from the wiring harness in the following locations:
- The lower pillar garnish molding
- The rear header area

INSTALLATION PROCEDURE




1. Install the antenna cable (1) to the vehicle. Use electrical tape in order to secure the antenna cable to the top of the wiring harness. Secure the cable to the harness at least every 150 mm (6 in).




2. Connect the antenna cable to the antenna extension cable.
3. Install the carpet.
4. Install the lower center pillar trim panel.
5. Install the left lower pillar garnish molding.




6. Connect the antenna cable (2) to the radio antenna module
7. Install the headliner.
8. Install the left rear upper quarter trim panel.
9. Install the left rear quarter lower trim panel.
10. Install the rear seat back.
11. Install the rear seat cushion.