Low Tire Pressure Indicator Does Not Reset
Low Tire Pressure Indicator Does Not Reset
| Step | Action | Yes | No |
|---|---|---|---|
| DEFINITION: The LOW TIRE indicator does not reset. | |||
| 1 | Did you perform the Tire Pressure Monitor Diagnostic System Check? | Go to Step 2 | Diagnostic System Check - Tire Pressure Monitoring |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 |
|
Go to Step 5 | Go to Step 4 |
| 4 | Test the reset switch signal circuit for a high resistance or an open. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 10 | Go to Step 7 |
| 5 | Test the ground circuit of the TIM reset switch for a high resistance or an open. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 10 | Go to Step 6 |
| 6 | Inspect for poor connections at the harness connector of the TIM reset switch. Refer to Testing for Intermittent Conditions and Poor Connections
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 10 | Go to Step 8 |
| 7 | Inspect for poor connections at the harness connector of the Body Control Module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 10 | Go to Step 9 |
| 8 | Replace the TIM reset switch. Refer to Instrument Panel Electrical Center or Junction Block Replacement
in Instrument Panel, Gages and Console. Did you complete the replacement? |
Go to Step 10 | - |
| 9 | Replace the BCM. Refer to Body Control Module Replacement
in Body Control Systems. Did you complete the replacement? |
Go to Step 10 | - |
| 10 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |