Security Indicator Inoperative

Step	Action	Yes	No
Schematic Reference: Theft Deterrent System Schematics
1	Did you perform A Diagnostic System Check-Theft Deterrent?	Go to Step 2	Go to Diagnostic System Check - Theft Deterrent
2	Observe the instrument cluster. Turn the ignition switch to the ON position. Does the SECURITY indicator illuminate during the bulb-check?	System OK	Go to Step 3
3	Replace the instrument cluster. Refer to Instrument Panel Cluster (IPC) Replacement in Instrument Panel, Gages and Console. Did you complete the repair?	Go to Step 4	-
4	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2