Adjustment Procedure
- Remove the instrument panel (I/P) cluster trim plate. Refer to Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster .
- Open the compartment door.
- Loosen the screws holding the compartment striker to the I/P.
- Adjust the striker for proper alignment to the I/P compartment.
Tighten: Tighten the screws to 2 N.m (18 lb in).
- Install the I/P cluster trim plate. Refer to Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster .
NOTE:
Refer to Fastener Notice in Cautions and Notices.