LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Regal GS >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Console Replacement - Front Floor >> Removal Procedure

Removal Procedure

  1. Apply the parking brake.
  2. Position the transaxle shift lever to the LOW position.
  3. Remove the floor console trim plate. Refer to Trim Plate Replacement - Console Front .
    4. Fig 1: Floor Console Trim Plate & Rear Compartment Mat
    GM326131Courtesy of GENERAL MOTORS CORP.
  4. Remove the rear compartment mat.
    5. Fig 2: Rear Compartment Bolts
    GM326124Courtesy of GENERAL MOTORS CORP.
  5. Remove the rear compartment bolts.
  6. Remove the bracket bolts rearward of the transaxle shift lever.
    7. Fig 3: Rear Compartment Horizontal Bolts Near I/P
    GM326126Courtesy of GENERAL MOTORS CORP.
  7. Remove the horizontal bolts near the instrument panel (I/P).
  8. Remove the power accessory port. Refer to Accessory Power Receptacle Replacement - Floor Console in Power Outlets.
  9. Remove the floor console lighter. Refer to Cigar Lighter Housing Replacement - Floor Console in Power Outlets.
    10. Fig 4: Floor Console Wiring Harness
    GM326133Courtesy of GENERAL MOTORS CORP.
  10. Disconnect the wiring harness from the floor console.
    11. Fig 5: Pulling Floor Console From I/P Retainers
    GM689957Courtesy of GENERAL MOTORS CORP.
  11. Pull the floor console rearward in order to release the retainers from the I/P.
    12. Fig 6: Depressing Front Edge Of Shift Trim Plate
    GM689951Courtesy of GENERAL MOTORS CORP.
  12. Depress the front edge of the shifter trim plate in order to pull back the floor console for removal.
  13. Remove the floor console from the vehicle.
scientia non olet · About LEMON Manuals