LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Wiring Systems) >> Repair Instructions >> Junction Block Replacement - Accessory Wiring >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Remove the instrument panel (I/P) compartment access hole cover.
    3. Fig 1: I/P Compartment Access Hole Cover
    GM1203017Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the body wiring harness from the accessory wiring junction block. Pull the harness away from the block for access.
    4. Fig 2: Body Wiring Harness & Accessory Wiring Junction Block Bolt
    GM928964Courtesy of GENERAL MOTORS CORP.
  4. Open the I/P compartment. Access the junction block bolt through the open I/P compartment. Remove the junction block bolt.
  5. Disengage the junction block tabs from the passenger knee bolster. Pull the junction block away from the I/P.
    6. Fig 3: Junction Block Tabs & Passenger Knee Bolster
    GM929411Courtesy of GENERAL MOTORS CORP.
  6. Remove the junction block.
scientia non olet · About LEMON Manuals