Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Install the generator rear brace (4).
Install the generator rear brace bolt (3).
Install the generator rear brace nut (5).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Tighten the generator bolts in the order described. The following is a mandatory torque sequence:
Tighten:
1. Tighten the generator rear brace bolt (3) to 50 N.m (37 lb ft).
2. Tighten the generator rear brace nut (5) to 50 N.m (37 lb ft).

Fig 1: Generator Rear Brace, Nut & Bolt (L26)

Courtesy of GENERAL MOTORS CORP.