LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Engine Controls Diagnosis 3.8L (DTC P0455 To P1404)) >> Diagnosis >> DTC P1351 >> Diagnostic Aids

Diagnostic Aids

WARNING: This page is about a different car, the 2004 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
DTC P1351

Step
 		 Action Values Yes No
Schematic Reference:  Engine Controls Schematics 
Connector End View Reference:  Engine Controls Connector End Views  or  Powertrain Control Module (PCM) Connector End Views 
1 Did you perform the Diagnostic System Check-Engine Controls? - Go to Step 2  Go to Diagnostic System Check - Engine Controls
2
  1. Observe the Freeze Frame/Failure Records for this DTC.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
Did the DTC fail this ignition?		 - Go to Step 3  Go to Intermittent Conditions
3
  1. Turn OFF the ignition.
  2. Disconnect the powertrain control module (PCM).
  3. Turn ON the ignition, with the engine OFF.
  4. Measure the voltage from the ignition control (IC) timing control circuit to the low reference circuit of the ignition control module (ICM) using a DMM.
Is the voltage within the specified value?		 20-40 mV Go to Step 5  Go to Step 4 
4
  1. Turn OFF the ignition.
  2. Leave the PCM disconnected.
  3. Disconnect the ICM.
  4. Test the IC timing control circuit for an open or for high resistance. Refer to Circuit Testing in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 9  Go to Step 6 
5 Test for an intermittent and for a poor connection at the PCM. Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 9  Go to Step 8 
6 Test for an intermittent and for a poor connection at the ICM. Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 9  Go to Step 7 
7 Replace the ICM. Refer to Ignition Control Module Replacement .
Did you complete the replacement?		 - Go to Step 9  -
8 Replace the PCM. Refer to Powertrain Control Module (PCM) Replacement .
Did you complete the replacement?		 - Go to Step 9  -
9
  1. Clear the DTCs with a scan tool.
  2. Turn OFF ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
Did the DTC fail this ignition?		 - Go to Step 2  Go to Step 10 
10 Observe the Capture Info with a scan tool.
Are there any DTCs that have not been diagnosed?		 - Go to Diagnostic Trouble Code (DTC) List System OK
scientia non olet · About LEMON Manuals