LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Level Indicator and Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Oil Level Indicator
    GM370840Courtesy of GENERAL MOTORS CORP.
  1. Install the oil indicator tube to the engine. Ensure that the O-ring is in place. Ensure that the oil level indicator tube is fully seated in the engine.
  2. Slide the oil indicator tube bracket onto the exhaust manifold stud.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the oil level indicator tube bracket nut on the exhaust manifold stud.

    Tighten:  Tighten the nut to 19 N.m (14 lb ft).

  4. Install the oil level indicator.
scientia non olet · About LEMON Manuals