LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Strut Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Mount Strut
    GM97613Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount strut.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolt and the nut to the left engine mount strut at the left engine mount strut bracket on the upper radiator support.

    Tighten:  Tighten the engine mount strut nut to 48 N.m (35 lb ft).

    3. Fig 2: Left Engine Mount Strut Bracket Bolt
    GM327335Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The P-clip on the engine wiring harness must be vertical, as shown, to the left engine mount strut bracket when installed.
  3. Position the P-clip to the left engine mount strut bracket bolt.
    4. Fig 3: Left Engine Mount Strut Bolt & Nut
    GM327466Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The engine mount strut bolt must always be installed as shown in the graphic.
  4. Install the bolt and the nut to the left engine mount strut at the left engine mount strut bracket on the engine.

    Tighten:  Tighten the engine mount strut nut to 48 N.m (35 lb ft).

scientia non olet · About LEMON Manuals