LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Strut Bracket Replacement - Right Upper (L36) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L36)  or Fuel Injector Sight Shield Replacement (L67) .
  3. Fig 1: View Of Right Engine Mount Strut To Upper Engine Mount Strut Bracket
    GM97620Courtesy of GENERAL MOTORS CORP.
  4. Remove the right engine mount strut from the upper engine mount strut bracket. Refer to Engine Mount Strut Replacement - Right .
  5. Fig 2: View Of Lower Engine Mount Bracket
    GM327637Courtesy of GENERAL MOTORS CORP.
  6. Remove the lower engine mount strut bracket nut.
  7. Remove the lower engine mount strut bracket bolts and the bracket.
  8. Remove the EVAP emissions canister purge valve. Refer to Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement (L36) or Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement (L67) in Engine Controls - 3.8L.
  9. CAUTION: Refer to Relieving Fuel Pressure Caution in Cautions and Notices.
  10. Relieve the fuel pressure. Refer to Fuel Pressure Relief Procedure in Engine Controls - 3.8L.
  11. Remove the fuel rail assembly. Refer to Fuel Rail Assembly Replacement (L36) or Fuel Rail Assembly Replacement (L67) in Engine Controls - 3.8L.
  12. Fig 3: Upper Engine Mount Strut Bracket & Bolts
    GM327736Courtesy of GENERAL MOTORS CORP.
  13. Remove the upper engine mount strut bracket bolts.
  14. Remove the upper engine mount strut bracket.