Installation Procedure
WARNING: This page is about a different car, the 2004 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
- Install the lower engine mount bracket to the exhaust manifold stud and the upper engine mount strut bracket.
- Install the lower engine mount strut bracket bolts.
Tighten: Tighten the lower engine mount bracket bolts to 50 N.m (37 lb ft).
- Install the lower engine mount strut bracket nut.
Tighten: Tighten the lower engine mount bracket nut to 30 N.m (22 lb ft).
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
NOTE:
Refer to Fastener Notice in Cautions and Notices.