LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Tensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. If replacing the drive belt tensioner, lubricate the thermostat bypass upper and lower pipe assembly seals with engine coolant and install the upper and lower pipe assemblies.
    2. Fig 1: View Of Drive Belt Tensioner
    GM326960Courtesy of GENERAL MOTORS CORP.
  2. Install the drive belt tensioner.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the drive belt tensioner bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  4. Install the heater hose adapters with the heater hoses to the drive belt tensioner. Refer to Heater Hose Replacement - Inlet (3.1L) or Heater Hose Replacement - Inlet (3.8L) and to Heater Hose Replacement - Outlet (3.1L) or Heater Hose Replacement - Outlet (3.8L) in Heating Ventilation and Air Conditioning.
  5. Install the generator. Refer to Generator Replacement (3.1L) or Generator Replacement (3.8L) in Engine Electrical.
  6. Install the drive belt. Refer to Drive Belt Replacement (L36)  or Drive Belt Replacement (L67) .
  7. Install the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement in Engine Cooling.
  8. Fill the cooling system. Refer to Draining and Filling Cooling System in Engine Cooling.
  9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
scientia non olet · About LEMON Manuals