Balance Shaft Bearing and/or Bushing Removal

WARNING: This page is about a different car, the 2004 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 36995 Balance Shaft Bearing Remover/Installer. See Special Tools and Equipment .

Fig 1: Removing Balance Shaft Bearing Using J 36995

Courtesy of GENERAL MOTORS CORP.

Use J 36995 to remove the balance shaft bearing. See Special Tools and Equipment .
Use J 36995 to remove the balance shaft bushing. See Special Tools and Equipment . It may take a considerable amount of force to loosen the bushing from the block bore.