Installation Procedure
WARNING: This page is about a different car, the 2004 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
- Install the knock sensor (1).
Tighten: Tighten the knock sensor to 19 N.m (14 lb ft).
- Connect the knock sensor electrical connector (2).
- Lower the vehicle.
- Fill the cooling system. Refer to Draining and Filling Cooling System in Engine Cooling.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
IMPORTANT:
DO NOT apply thread sealant to sensor threads. The sensor is coated at factory and applying additional sealant will affect the sensors ability to detect detonation.