Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.

Install the ignition coil (2).

Fig 1: View Of Ignition Coil Module And Module Mounting Bracket

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the ignition coil screws (1).
Tighten: Tighten the screws to 4.5 N.m (40 lb in).
Connect the spark plug wires.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.