LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Engine Controls 3.8L (Introduction, Service & Replacement)) >> Repair Instructions >> Heated Oxygen Sensor Replacement - Position 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of HO2S (Position 2)
    GM402074Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: A special anti-seize compound is used on the oxygen sensor threads. New service sensors should already have the compound applied to the threads. Coat the threads of a reused sensor with anti-seize compound P/N 12377953 or equivalent.
  1. Install the oxygen sensor (4) to the exhaust pipe.

    Tighten:  Use the J 39194  to tighten the oxygen sensor to 41 N.m (30 lb ft).

  2. Connect the HO2S electrical connector to the HO2S electrical harness connector (2).
  3. Install the retaining tab (1) to the HO2S electrical connector.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals