LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Engine Controls 3.8L (Introduction, Service & Replacement)) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Chassis/Canister >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: View Of Fuel Filter & Pipes
    GM699549Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the evaporative emission (EVAP) purge pipe connector at the fuel filter area. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    3. Fig 2: Locating EVAP And Fuel Tank Components
    GM699561Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the EVAP purge pipe (8) from the EVAP canister (1). Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  4. Remove the EVAP purge pipe (8).
scientia non olet · About LEMON Manuals