LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Engine Controls 3.8L (Introduction, Service & Replacement)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement (L36) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Canister Purge Valve (L36)
    GM217748Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister purge valve onto the EVAP canister purge valve mounting bracket.
    2. Fig 2: View Of EVAP Canister Purge Valve Purge Pipe, Electrical Connector & Vacuum Supply Hose (L36)
    GM486596Courtesy of GENERAL MOTORS CORP.
  2. Connect the EVAP canister purge valve purge pipe and vacuum supply hose.
  3. Connect the EVAP canister purge valve harness connector.
  4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L36) or Fuel Injector Sight Shield Replacement (L67) in Engine Mechanical - 3.8L.
scientia non olet · About LEMON Manuals