LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Engine Controls 3.8L (Introduction, Service & Replacement)) >> Repair Instructions >> Bypass Valve Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Bypass Valve Actuator
    GM21738Courtesy of GENERAL MOTORS CORP.
  1. Install the J 39363 to the actuator.
    2. IMPORTANT: When installing the bypass valve actuator to the supercharger, rotate the assembly until the bypass valve shaft lever comes in contact with the stop block.
  2. Rotate the actuator until the rod engages the lever.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bypass valve actuator bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  4. Remove the J 39363 .
  5. Install the vacuum hoses to the bypass actuator.
  6. Install the boost control solenoid. Refer to Boost Control Solenoid Replacement .
  7. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L36) or Fuel Injector Sight Shield Replacement (L67) in Engine Mechanical - 3.8L.
scientia non olet · About LEMON Manuals