LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Engine Controls Diagnosis (DTC P1380 To DTC P2229) - 3.8L) >> Diagnosis >> DTC P1660 >> Diagnostic Aids

Diagnostic Aids

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
DTC P1660

Step Action Yes No
Schematic Reference: Engine Controls Schematics
Connector End View Reference:  Engine Controls Connector End Views  or  Powertrain Control Module (PCM) Connector End Views 
1 Did you perform the Diagnostic System Check-Engine Controls? Go to Step 2  Go to Diagnostic System Check - Engine Controls
2 Is DTC P0560 set? Go to Diagnostic System Check - Engine Electrical in Engine Electrical Go to Step 3 
3 Observe the Output Driver Data List with a scan tool.
Do any parameters indicate a fault present?
Go to Step 4  Go to Step 5 
4 Test for a short to voltage on the control circuit of the component that indicated a fault. Refer to Testing for a Short to Voltage in Wiring Systems.
Did you find and correct the condition?
Go to Step 6  Go to Step 5 
5 Replace the PCM. Refer to Powertrain Control Module (PCM) Replacement .
Did you complete the replacement?
Go to Step 6  -
6
  1. Clear the DTCs with a scan tool.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
Does the DTC fail this ignition?
Go to Step 2  Go to Step 7 
7 Observe the Capture Info with a scan tool.
Are there any DTCs that have not been diagnosed?
Go to Diagnostic Trouble Code (DTC) List System OK