Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Install the exhaust manifold pipe gasket (1).
- Install the exhaust system to the original position
- Install the catalytic converter exhaust hangers.
- Remove the support from the exhaust system.
- Install the exhaust manifold pipe stud nuts (2).
Tighten: Tighten the nuts to 35 N.m (26 lb ft).
- Connect the HO2S electrical connector.
- Inspect the exhaust system for leaks and underbody contact.
- Lower the vehicle.
NOTE:
Refer to Fastener Notice in Cautions and Notices.