Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Align the retaining tabs and install the recirculation housing to the HVAC module assembly.
- Install the recirculation housing screws.
Tighten: Tighten the screws to 1.5 N.m (13 lb in).
- Align the slots on the recirculation actuator to the slots on the recirculation door shaft.
- Install the recirculation actuator on to the recirculation door shaft.
- Install the recirculation actuator screws.
- Tighten the recirculation actuator screws.
Tighten: Tighten the screws to 1.5 N.m (13 lb in).
- Install the HVAC module assembly. Refer to HVAC Module Assembly Replacement .
NOTE:
Refer to Fastener Notice in Cautions and Notices.