Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the accessory drive belt from the A/C compressor. Refer to Drive Belt Replacement (L26) or Drive Belt Replacement (L32) in Engine Mechanical - 3.8L.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the lower air deflector. Refer to Radiator Air Baffle and Deflector Replacement - Lower in Engine Cooling.
- Remove and discard the compressor clutch plate bolt.
Use the J 37872 to hold the compressor clutch plate from turning. See Special Tools and Equipment .
- Remove the compressor clutch plate from the compressor.
- Remove the compressor pulley snap ring using the J 6083 . See Special Tools and Equipment .
- Remove the compressor pulley from the compressor.
- Remove the compressor clutch coil snap ring using the J 6083 . See Special Tools and Equipment .
- Remove the compressor clutch coil from the compressor.
IMPORTANT:
Remove the three adjustable dowels from J 37872
. See Special Tools and Equipment .
Install three 5/16x1 inch bolts in place of the dowels.
Install three 5/16x1 inch bolts in place of the dowels.