Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Side Window Defog Outlet Grille (Right)

Courtesy of GENERAL MOTORS CORP.

Align the side window defog outlet grille to the I/P trim pad.

Fig 2: Side Window Defog Outlet Grille Screw (Right)

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Use a flexible driver with a PHILLIPS® bit to install the side window defog outlet grille screw.
Tighten: Tighten the screw to 2 N.m (18 lb in).

Fig 3: Body Wiring Harness & Accessory Wiring Junction Block

Courtesy of GENERAL MOTORS CORP.

Connect the body wiring harness to the accessory wiring junction block. Tighten the connector bolt.
Tighten: Tighten the connector bolt to 2.5 N.m (22 lb in).
Reposition and install the wire retainers at the I/P opening.

Fig 4: Right I/P Compartment Access Hole Cover

Courtesy of GENERAL MOTORS CORP.

Install the right I/P compartment access hole cover to the I/P trim pad.