Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: I/P Center Air Outlet

Courtesy of GENERAL MOTORS CORP.

Position the I/P center air outlet to the I/P accessory trim plate.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the I/P center air outlet screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 2: Electrical Connector & Driver Information Display Assembly

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector to the driver information display.

Fig 3: I/P Accessory Trim Plate (Center)

Courtesy of GENERAL MOTORS CORP.

Align the I/P accessory trim plate to the I/P trim pad. Install the I/P accessory trim plate.
Install the ignition switch bezel.