Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the instrument panel trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) in Instrument Panel, Gages, and Console.
- Remove the screws and the center air duct.
- Remove the screws and the RH side air duct.
- Remove the screws and the LH side air duct.
- Remove the bolt from the accessory wiring junction block.
- Disengage the junction block tabs from the passenger knee bolster. Remove the junction block from the knee bolster.
- Disconnect the booster push rod from the brake pedal.
- Remove the brake pedal. Refer to Brake Pedal Assembly Replacement in Hydraulic Brakes.
- Remove the brake pedal brace bolts from the I/P carrier cross car beam.
- Lower the body control module (BCM) away from the I/P carrier.
- Disconnect any ground wires, as necessary.
- Reposition the I/P wiring harness out of the way.
- Remove the bracket bolts from the HVAC module center support.
- Remove the bracket bolts from the HVAC module upper support.
- Remove the right and the left I/P carrier bolts.
- Remove the I/P carrier.
- Remove the cross car air duct bolts from the I/P carrier.
- Remove the cross car air ducts from the I/P carrier.