LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Rear Suspension System) >> Repair Instructions >> Wheel Bearing/Hub Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wheel Bearing/Hub & Backing Plate
    GM1228560Courtesy of GENERAL MOTORS CORP.
  1. Install the backing plate (2) and the wheel bearing hub (3).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the wheel bearing/hub-to-knuckle bolts.

    Tighten:  Tighten the bolts to 75 N.m (55 lb ft).

    3. Fig 2: ABS Electrical Connector & Wheel Speed Sensor
    GM305363Courtesy of GENERAL MOTORS CORP.
  3. Install the ABS electrical connector to the wheel speed sensor (1), if equipped.
  4. Install the brake rotor and caliper. Refer to Brake Rotor Replacement - Rear (RPO J65, JL9) in Disc Brakes.
  5. Install the tires and wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals