LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Stabilizer Shaft Link Nut
    GM236116Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft link (1) to the vehicle.
  2. Connect the stabilizer shaft link (1) to the stabilizer shaft (2).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the stabilizer shaft link nut to the stabilizer shaft link (1) and the stabilizer shaft (2).

    Tighten:  Tighten the nut to 45 N.m (33 lb ft).

    4. Fig 2: View Of Stabilizer Shaft Link
    GM614968Courtesy of GENERAL MOTORS CORP.
  4. Connect the stabilizer shaft link (2) to the strut.
  5. Install the stabilizer shaft link nut (1)) to the stabilizer shaft link (2) and the strut.

    Tighten:  Tighten the nut to 45 N.m (33 lb ft).

  6. Lower the vehicle.
scientia non olet · About LEMON Manuals