Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Refer to Park Brake Cable to Caliper Caution
in Cautions and Notices.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Relieve the cable tension at the park brake equalizer.
- Disconnect the front cable from the connector (2).
- Remove the front cable from the equalizer.
- Remove the front cable from the cable guides.
- Lower the vehicle.
- Remove the left side closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
- Remove the lower center pillar panel on the left side and the left side carpet retainers. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
- Fold back the carpeting in order to gain access to the front park brake cable.
- Remove the retaining clip and disconnect the cable button from the clevis.
- Use a 13 mm box-end wrench to release the retainer holding cable to the bracket on the pedal assembly.
- Remove the front cable from the vehicle.
Note routing of the cable for installation.