Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Install the front cable into the vehicle as noted in the removal procedure.
- Install the front park brake cable into the bracket on the park brake assembly.
- Insert the cable button end into the clevis and install the retaining clip.
- Reposition the carpeting properly.
- Install the left side carpet retainers and the lower center pillar panel on the left side. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
- Install the left side closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Install the front park brake cable through the park brake cable guides.
- Install the front park brake cable into the equalizer.
- Connect the front park brake cable (1) to the rear cable (3) at the connector clip (2).
- Tighten the nut on the equalizer (2) in order to remove slack in the cable.
- Lower the vehicle.
- Adjust the park brake system. Refer to Park Brake Adjustment .