Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Install the O-ring (11) to the VSS (10).
- Install the VSS (10).
- Install the VSS stud (9).
Tighten: Tighten the stud to 11 N.m (97 lb in).
- Install the wiring harness retainer on stud.
- Connect the VSS electrical connector.
- Install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Lower the vehicle.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.