LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Transmission Fluid Pressure (TFP) Manual Valve Position Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of TFP Manual Valve Position Switch
    GM48220Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When installing the TFP switch handle the switch carefully, the fluid pressure manual valve position switch is very delicate.
  1. Carefully install the fluid pressure manual valve position switch (395).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the control valve body bolts (375, 379, 381) that mount the fluid pressure manual valve position switch to the control valve body (300).

    Tighten: 

    • Tighten the control valve body bolt (375) to 12 N.m (106 lb in).
    • Tighten the control valve body bolt (379) to 16 N.m (106 lb in).
    • Tighten the control valve body bolt (381) to 8 N.m (70 lb in).

  3. Connect the transaxle wiring harness.
  4. Install the case side cover. Refer to Case Side Cover Replacement .
scientia non olet · About LEMON Manuals