LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Transmission Fluid Cooler Connector Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Oil Cooler Fittings
    GM627406Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: The correct thread engagement is critical. Cross-threaded fittings can achieve proper tightness and still leak.
  1. Install the oil cooler fittings (28,29) to the transaxle.

    Tighten:  Tighten the fittings to 38 N.m (28 lb ft).

  2. Install the oil cooler hoses to the transaxle oil cooler fittings. Refer to Automatic Transmission Oil Cooler Hose Replacement .
  3. Lower the vehicle.
    4. NOTE: Refer to Transmission Overfill Notice in Cautions and Notices.
  4. Adjust the fluid level.
  5. Inspect for fluid leaks. Refer to Fluid Leak Diagnosis .
  6. Remove the drain pan from under the vehicle.
scientia non olet · About LEMON Manuals