LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Switch Replacement - Automatic Transmission Manual Shift Auxiliary Position - Steering Wheel >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Automatic Transmission Shift Auxiliary Position Switches
    GM1228531Courtesy of GENERAL MOTORS CORP.
  1. Install the automatic transmission shift auxiliary position switches (2).
  2. Connect the electrical connectors.
  3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the screws to the automatic transmission shift auxiliary position switches (1).

    Tighten:  Tighten the automatic transmission shift auxiliary position switch retaining screws to 3.5 N.m (31 lb in).

  5. Fig 2: Electrical Connectors & Radio Control Switches
    GM1228526Courtesy of GENERAL MOTORS CORP.
  6. Connect the electrical connectors to the radio control switches (2).
  7. Install the steering wheel radio controls (2).
  8. Install the retaining screws (1) to the steering wheel radio controls (2).

    Tighten:  Tighten the radio control retaining screws to 3.5 N.m (31 lb in).

  9. Enable the SIR System. Refer to SIR Disabling and Enabling Zone 3 in SIR.