Park Lock Cable Adjustment
WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Place the shift lever in the PARK position.
- Place the ignition key in the LOCK position.
- Ensure the shift lever cannot move to another position. The ignition key should be removable from the ignition switch.
- Place the ignition key in the RUN position.
- Place the shift lever in the NEUTRAL position.
- Ensure that the ignition key cannot turn to the LOCK position.
- The system is properly adjusted if the above conditions are met. Proceed to Step 13.
- If the above conditions are not met proceed to Step 9.
- Remove the front floor console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages, and Console.
- Disengage lock in adjuster body by squeezing release tabs and pulling away from cable body. Cable should move freely within adjuster body.
- Readjust the cable connector as outlined.
- Push the cable adjustment feature until all slack is removed from cable and no gap exists between cable end and adjustment feature.
- Depress cable lock.
- Retest the operation.
- If the ignition key cannot be removed in the PARK position, repeat adjustment procedure until key can be moved from the ignition.
- Install the front floor console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages, and Console.