LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Output Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Drive Axle Retainer Rings & Output Shaft
    GM214419Courtesy of GENERAL MOTORS CORP.
  1. Install the drive axle retainer rings (509) to the output shaft (510).
  2. Hold the front differential carrier in place and carefully install the output shaft (510) to the transmission through the left wheel opening. Extend the output shaft through the differential side gear.
  3. Install the case extension housing. Refer to Case Extension Housing Replacement .
  4. Install the left drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
scientia non olet · About LEMON Manuals