LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Automatic Transmission Mount Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the transaxle bracket to the transaxle.
    2. Fig 1: View Of Transaxle Mount Bracket And Bolts
    GM161246Courtesy of GENERAL MOTORS CORP.
  2. Hand start the transaxle mount bracket to transaxle bolts.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the transaxle bracket bolts.

    Tighten:  Start with the forward lower bolt and work clockwise to tighten the transaxle bracket bolts to 95 N.m (70 lb ft).

  4. Remove the support from the transaxle.
    5. Fig 2: Transaxle Bracket & Transaxle Mount Upper Nuts
    GM161248Courtesy of GENERAL MOTORS CORP.
  5. Install the transaxle bracket to the transaxle mount upper nuts.

    Tighten:  Tighten the nuts to 47 N.m (35 lb ft).

  6. Install the left engine splash shield. Refer to Splash Shield Replacement - Engine Body Front End.
  7. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals