LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Automatic Transmission Brace Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transaxle Brace
    GM1597356Courtesy of GENERAL MOTORS CORP.
  1. Install the transaxle brace (2).
  2. Hand start the bolts to the engine and to the transaxle.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the transaxle brace bolts (3) to the transaxle.

    Tighten:  Tighten the bolts to 43 N.m (32 lb ft).

  4. Install the transaxle brace bolts (1) to the engine.

    Tighten:  Tighten the bolts to 63 N.m (46 lb ft).

  5. Install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Lower the vehicle.
  7. Connect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical
scientia non olet · About LEMON Manuals