Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Outer Tie Rod Assembly To Inner Tie Rod Assembly

Courtesy of GENERAL MOTORS CORP.

Install the outer tie rod assembly (3) to the inner tie rod assembly (1). Do NOT tighten the jam nut (2).

Fig 2: Outer Tie Rod Assembly & Steering Knuckle

Courtesy of GENERAL MOTORS CORP.

Install the outer tie rod assembly (2) to the steering knuckle (1).

Fig 3: Prevailing Torque Nut & Outer Tie Rod Assembly

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the prevailing torque nut (2) to the outer tie rod assembly (1).
Tighten: Tighten the nut to 46 N.m (34 lb ft).
Install tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Lower the vehicle.
Perform a front end alignment. Refer to Measuring Wheel Alignment in Wheel Alignment.