LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (Power Steering System) >> Repair Instructions >> Power Steering Pressure Pipe/Hose Replacement (L26 and L32) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power steering pressure hose to the vehicle.
    2. Fig 1: Power Steering Pressure Hose (L26/L32)
    GM1206116Courtesy of GENERAL MOTORS CORP.
  2. Install the power steering pressure hose to the clamps on the power steering gear.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the power steering pressure hose to the power steering pump.

    Tighten:  Tighten the fitting to 27 N.m (20 lb ft).

    4. Fig 2: View Of Power Steering Hoses - 3.8L
    GM294335Courtesy of GENERAL MOTORS CORP.
  4. Install the power steering pressure hose to the power steering gear.

    Tighten:  Tighten the pressure hose fitting to 27 N.m (20 lb ft).

  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels
  6. Remove the drain pan from under the vehicle.
  7. Lower the vehicle.
  8. Install the accessory drive belt. Refer to Drive Belt Replacement (L26) or Drive Belt Replacement (L32) in Engine Mechanical-3.8L.
  9. Fill the power steering system with power steering fluid. Refer to Checking and Adding Power Steering Fluid .
  10. Bleed the power steering system. Refer to Bleeding the Power Steering System .
  11. Inspect the power steering system for leaks. Refer to Power Steering Fluid Leaks .
scientia non olet · About LEMON Manuals