Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Install the new valve rocker arm cover gasket.
- Install the right valve rocker arm cover.
- Apply thread lock compound GM P/N 12345493 (Canadian P/N 10953488) or equivalent to the valve rocker arm cover bolt threads.
- Install the right valve rocker arm cover bolts.
Tighten: Tighten the bolts to 10 N.m (89 lb in).
- Install the right engine lift bracket (1) to the exhaust manifold.
- Install the right engine lift bracket bolt (2) and the nut (3).
Tighten: Tighten the bolt and the nut to 30 N.m (22 lb ft).
- Install the fuel injector sight shield bracket to the exhaust manifold.
- Install the fuel injector sight shield bracket nuts.
Tighten: Tighten the nuts to 30 N.m (22 lb ft).
- Install the right spark plug wires to the right spark plugs. Refer to Spark Plug Replacement in Engine Controls - 3.8L.
- Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
- Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L26) or Fuel Injector Sight Shield Replacement (L32) .
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
- Check and fill the crankcase as necessary.
- Inspect for oil leaks.
IMPORTANT:
Ensure that the valve rocker arm cover gasket is seated properly in the valve rocker arm cover groove.
NOTE:
Refer to Fastener Notice in Cautions and Notices.