LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Strut Bracket Replacement - Right Upper (L32) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Remove the ignition coil. Refer to Ignition Coil(s) Replacement in Engine Controls - 3.8L (L26 and L32).
    3. Fig 1: Identifying Ignition Coil
    GM153564Courtesy of GENERAL MOTORS CORP.
  3. Remove the supercharger drive belt. Refer to Drive Belt Replacement (L26)  or Drive Belt Replacement (L32) .
  4. Remove the upper supercharger drive belt idler pulley. Refer to Drive Belt Idler Pulley Replacement - Upper .
    5. Fig 2: Upper Drive Belt Idler Pulley & Bolt
    GM370453Courtesy of GENERAL MOTORS CORP.
  5. Remove the supercharger drive belt tensioner. Refer to Drive Belt Tensioner Replacement - Supercharger .
    6. Fig 3: Supercharger Drive Belt Tensioner & Nut
    GM97873Courtesy of GENERAL MOTORS CORP.
  6. Remove the right engine mount strut at the right engine mount strut bracket. Refer to Engine Mount Strut Replacement - Left  and Engine Mount Strut Replacement - Right .
    7. Fig 4: Right Engine Mount Strut Bolt & Nut (L32)
    GM1210282Courtesy of GENERAL MOTORS CORP.
  7. Remove the right engine mount strut bracket nuts and stud.
  8. Remove the right engine mount strut bracket from the cylinder head.
    9. Fig 5: Right Engine Mount Strut Bracket Nuts & Stud
    GM97874Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals