Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Install the upper engine mount strut bracket.

Fig 1: Upper Engine Mount Strut Bracket & Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the upper engine mount strut bracket bolts.
Tighten: Tighten the bolts to 50 N.m (37 lb ft).
Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L26) or Fuel Injector Sight Shield Replacement (L32) .
Install the lower engine mount strut bracket bolts.
- Tighten the lower engine mount strut bracket nut.
  Tighten: Tighten the nut to 30 N.m (22 lb ft).
- Tighten the lower engine mount strut bracket bolts.
  Tighten: Tighten the bolts to 50 N.m (37 lb ft).

Fig 2: Lower Engine Mount Strut Bracket Nut

Courtesy of GENERAL MOTORS CORP.

Install the right engine mount strut at the upper engine mount strut bracket. Refer to Engine Mount Strut Replacement - Left and Engine Mount Strut Replacement - Right .

Fig 3: Right Engine Mount Strut Bolt & Nut (L26)

Courtesy of GENERAL MOTORS CORP.

Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.