LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the motor mount on the frame
  2. Use the jackstand to lower the motor mount bracket on to the motor mount.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the motor mount to frame bolts.

    Tighten:  Tighten the nuts to 47 N.m (35 lb ft).

    4. Fig 1: Motor Mount & Frame Nuts
    GM1212272Courtesy of GENERAL MOTORS CORP.
  4. Install the Motor mount to Motor mount bracket nuts.

    Tighten:  Tighten the nuts to 47 N.m (35 lb ft).

    5. Fig 2: Motor Mount & Bracket Nuts
    GM43405Courtesy of GENERAL MOTORS CORP.
  5. Install the engine splash shield. Refer to Splash Shield Replacement - Engine in Body Front End.
  6. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals