LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission. Refer to Transmission Replacement in Automatic Transaxle - 4T65-E.
  2. Remove the drive belt. Refer to Drive Belt Replacement (L26)  or Drive Belt Replacement (L32) .
    3. IMPORTANT: Do not discharge the air conditioning system.
  3. Remove the A/C compressor from the engine. Refer to Compressor Replacement (L26 L32) in Heating, Ventilation and Air Conditioning.
  4. Secure the compressor away from the bracket area.
  5. Remove the engine mount. Refer to Engine Mount Replacement .
  6. Remove the engine knock sensor shield and disconnect the sensor harness. Refer to Knock Sensor (KS) 2 Replacement in Engine Controls - 3.8L (L26 and L32).
  7. Remove the front engine mount bracket bolts from the engine.
    8. Fig 1: Front Engine Mount Bracket Bolts
    GM97800Courtesy of GENERAL MOTORS CORP.
  8. Remove the rear engine mount bracket bolts from the engine.
    9. Fig 2: Rear Engine Mount Bracket Bolts
    GM97804Courtesy of GENERAL MOTORS CORP.
  9. Remove the engine mount bracket from the vehicle.
scientia non olet · About LEMON Manuals